Search results

It used to run trouble free it just takes a lot of time and many trials to restore it where it was. I thougnt there might be other adjustments or thing to look for regarding the dampening system.

I remember that the last time I had this kind of problem the water ductor eccentrics needed a lot of adjustments while printing resulting in a lot of waste

There is no separate water form roller. The first ink form roller acts as a dampener as well, I think your are right there is too much water because when I alter the adjustments for this roller still the problem persists.

I readjusted the form rollers to 2.5 and 3.5mm, no bouncing anymore. But I get scumming on the side of the leading edge of the plate which soon extends to the centre, although I get very weak colors, so emulsification and scumming at the same time. I adjusted the plate to blanket pressure and...

I ment that I get a 3/4 inch (2 cm) bead on the lead edge of the plate while printing. The forms are adjusted to 2.5mm and 4mm..

upper form is 2.5 mm lower (bigger) form is 4mm. How is chech or measure plate to blanket pressure..

After adjusting form rollers and plate to blanket cylinder pressure, I get a 2cm stip pf ink at the top of the plate, before adjustments it was 2mm and causing no problems. I operate an Abdick 8810.. Please advice..

Hi Washingtonmike Can I get that manual please. I'm based overseas where Abdicks are so rare. [email protected]