Hi, I have a 375CD with trouble feeding. It drops the paper at or just after the transfer from impression cylinder to the CD. I have taken the gripper bars out and cleaned them. I notice one of the actuator levers that opens and closes the grippers is cracked. I have a replacement lever, but wonder what is the proper procedure to setup the angle of this lever with respect to the shaft/gripper fingers. The cracked one has a very different angle than the others. I could copy the angle but I have no reason to believe the others are correct. As a general service question, which service manual should I look for for this machine? Is a 360 manual as close as I can get?
Thanks, mark
Thanks, mark
