Adjusting Output Color on Versant 80 with Fiery

[Stickman42]

We recently replaced our Xerox DocuColor 5000 and 7000 (which both had Creo RIPs) with identical Versant 80's with Fiery EX-80 RIPs. Sometimes the output needs a color adjustment. On the Creo, we were able to adjust what was known as the "Gradation" curve, which was accessed through the job properties. Each of the 4 colors could be adjusted individually. I am looking for a comparable method for use on the Fiery's. Anyone have any suggestions?

 

[DYP]

Go Device Center/Resources/Profile and edit with Color Editor the output profile for your job. You might want to save the adjustment with a different name. This should be similar to what you have been used to with Creo.

 

[Stickman42]

Exactly what I was looking for. Last step is to apply the output profile in the individual job properties > color tab (for anyone else who might be new to this like me). Thanks very much!

 

[Stickman42]

I now realize I should have posted this in another forum section, not in Postpress. Apologies for any inconvenience. If a moderator can move the thread, please do so.

 

[prwhite]

"I now realize I should have posted this in another forum section, not in Postpress. Apologies for any inconvenience. If a moderator can move the thread, please do so."

Done.