Gas Ghosting

[everton69]

Morning world - another day in the wibbly wobbly world of print.
We have an issue on an uncoted board of what I beleive is gas ghosting.
Job printed fine - left 24 hour then went for SPOT u/ving.
Came back - all ok.
Left for a further 3 days and wham job looks dreadful.
Any ideas?

 

[Al Ferrari]

Is the stock printed 4 over 4?
Is the spot U/V also 4 over 4?

We only know what you tell us about the job.

 

[everton69]

Single colour Pan 5645 t/out

 

[Freeman A.Gain]

Why did you need to leave it for 3 more days after spot uv? Is the gas ghosting coming from print on other side or print trying to come through the UV?

 

[SHELBY]

Morning world - another day in the wibbly wobbly world of print.
We have an issue on an uncoted board of what I beleive is gas ghosting.
Job printed fine - left 24 hour then went for SPOT u/ving.
Came back - all ok.
Left for a further 3 days and wham job looks dreadful.
Any ideas?

If its chemical ghost, you need to get air into it before it happens.Not sure what your job looks like so . Lots of time with a chemical ghost if this is what you have, you can lay a varnish over it, air it within a hour or so very gently......send her back for spot, air again. The key is air here.