• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

Image fading at lead edge of plate - DPM34HSC

CathieHarris

Well-known member
Hi all.

I've been running plates on this processor (DPM34HSC) for quite a while with no issues. Suddenly, yesterday, when I ran plates, I notice it was cutting off, actually fading off, the top type/image that's closest to the gripper. I'm using ABDick PrintersRIP, poly plates, 13,375" in length.

I can move down my artwork by 3/16" on the Mac and resend the file and it's fine, but if I butt it up to the gripper edge, like I've always done, and anything is within that top 3/16" area, it fades off.

Any ideas?

Thanks
Cathie
 
If you run 2 plates out at the same time and the second one is OK, you might find that light is getting in some where.
 

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top