Clipper Print Ltd
New member
Hi
We're running a Linotronic 630 with a PC Rip (Xitron Navigator v7) - everything was OK till 2 weeks ago where it now fails to complete the boot process. It'll communicate so far with the RIP but fails to complete the whole sequence - it just gets stuck with the word BOOT in the Lino 630 display panel.
We've had someone come out to have a look but without success. The software on the rip has also been checked by a professional and no fault has been found there.
If any one has any advice we would surely appreciate it.
Kind regards
Chris (Designer/PrePress)
We're running a Linotronic 630 with a PC Rip (Xitron Navigator v7) - everything was OK till 2 weeks ago where it now fails to complete the boot process. It'll communicate so far with the RIP but fails to complete the whole sequence - it just gets stuck with the word BOOT in the Lino 630 display panel.
We've had someone come out to have a look but without success. The software on the rip has also been checked by a professional and no fault has been found there.
If any one has any advice we would surely appreciate it.
Kind regards
Chris (Designer/PrePress)
