Looking for a Komori LMU-TK12ASTR Monitor

[ITGuy]

Anyone know a good source (other than ebay) to get a Komori LMU-TK12ASTR monitor? The monitor that we have is made by Sanyo.

 

[Servicetech]

Do you need the monitor for the console operation itself or the KMS/PDCS computer in the console?

The reason I ask is I once installed a Chinese touch screen for a customer on their PDCS computer. This console had 2 identical Sanyo monitors on it, worked fine, the PDCS is just runs on a Windows PC inside the console, the mechanical installation was the hardest part but it came out nice. Just power, VGA, and RS232 hookup, installed the windows drivers and calibrated it.

If you are needing it for the press operation, I'm not sure if this is an option. I never tried a different monitor there, I do remember the Sanyo will only display 800X600 resolution. A display problem or touch driver problem with a different monitor would be difficult to deal with here, no way to install different device drivers.

Many of Komori's electrical parts are notoriously difficult to purchase in the USA, aside from Komori anyway.

here is a manual on the Sanyo that may be of some help
www.datasheetcatalog.org/datasheets/restul/502180_DS.pdf

Good hunting

 

[ITGuy]

Thanks for the reply. We need the monitor for the console. There a couple of the refurb Sanyo monitors on Ebay but I think these are only short term solutions.

 

[Presselectronucs]

Whats wrong with Ebay? I buy from there all the time. Just check their Feedback Rating and make sure it up by 100% and you should have no problem.

I personally have bought three Komori monitors myself. One of the LMU-TK12ASTR and two of the Somic68K's. Just bought some golf clubs too. . .