polar em 115 error 86

[Adnan Azzam]

Hi evry body pls does any one know the error 86 in polar EM 115
regardadnan

 

[Magnus59]

The official explanation for this error message tells you:
Meaning:
A static discrepancy does exist between the outputs of both cutting circuit channels (HK and IAR). LED`s V2 and V3 on the board KK (supervisor) are lit up permanently.
Remedy:
Check the fuse holder for fuse F4.
- It is on the left side where the big transformer for the power supply is located
Check voltage +42 V on plug CU9.2.
- This is in the rear side of the mother board. The mother board or central unit is the big board where all the other electronic boards are plugged in.
Check basic condition of LED V14 on board KK for cutting buttons activated within 0.5 sec.
Check basic condition of LED V15 on board KK for Signal starting cutting
Check basic condition of LED V16 on board KK for safety bolt activated
Check basic condition of LED V17 on board KK for Signal starting clamping
Check basic condition of LED V18 on board KK for light barrier test completed
If one of these LED´s (14 to 18) is lit up exchange card KK.

 

[Adnan Azzam]

Thanks Mr Magnus for your kind reply
best regards
Adnan

 

[chock]

Hi sir :
I did reply you yesterday in color printing Forum
i repeated you again.

Hi sir:
86 mean:
Problem: 1) discrepancy does exist between the output of both cutting circuit channels (hardware channel
LED V2 and V3 KK are lit up permanently:
Test : a) Check voltage + 42 V on plug CU 9.2 (safety bolt)
b)Check basic conditions of LED’s V14- V18 HK if one of this are LED's are lit up
Remedy: Replace HK board
c) LED’s Vl - V3, VI9 and V23 IAR (if NOT according) replace IAR
d) Check connection AR - IAR (flat wire harness)
Exchange card AR o KK
Let me know
Blessing
[email protected]
Mobile+WhatsApp:+505 8861 1441

 

[chock]

Did you fix it sir?
Let me know
Blessing
[email protected]
Mobile+WhatsApp:+505 8861 1441