problem wit concentric screen

[pam_add]

after i setup all things ( programs , license ....)
i create a concentric screen based on V3 grill concentric screen far i as remember now
all things is ok but when i rip any file with screens like this C15 M75 y0 k 45 after successfully rip as appear in log file BOOM the cyan and magenta angles is same 15 only ..

i used suite 7.4 anyone have the same problem ?

 

[DavidMa]

Go to your RIP and launch Screen Manager. Open the Screen you created and check to see what angles are supported (should be on the right hand side of the window), you may not have a 75, so it defaults to 15.

 

[pam_add]

i know sou

i know sou

no i have 75 and rip log prove that
but the output is 15

 

[DavidMa]

OK, since your log file says it's outputting a 75, what device are you outputting to, maybe it doesn't support 75?

just a stab in the dark here.

 

[DavidH]

no i have 75 and rip log prove that
but the output is 15

Have you contacted your local Esko support organization? Please PM me and I will put you in touch with them.

Regards,
David