Screen PTR-6600E

[Prepper]

What would be the recommended interval for optics cleaning and any preventive maintenance for this kind of CTP in a low use shop in a climate controlled, clean room? It's been a couple of years since our last cleaning but we've only put around 5,000 plates thru it in that amount of time.

Thanks for any info

 

[ansoft]

First check VP41 (M41) for the necessary air volume. I think 6 months is ok for your case.

 

[Gramann]

It also depends on the plate type, ie, Kodak, Fuji. Some plates ablate more than others and can coat the final lens more quickly.

 

[Prepper]

Platesetter PM

Platesetter PM

Yes, I remember hearing that about some plates, we are using Fuji, which don't have much of that at all I don't think.

 

[Gramann]

You are correct, the Fuji plates don't ablate much, but there is still some.
Wouldn't hurt to inspect the final lens about once a month.
If it were my machine, I would check it every time I cleaned the external air filter.
Much cheaper than replacing lasers.

 

[ansoft]

Gramann is absolutely right!
But if you set the correct laser power, the ablation will be low.
Once a month just for checking is ok, but cleaning more rare