scotts
Well-known member
We just started to notice some striations in the image of our Sonora XTRA plates that show up on the print. You have to look under a loop to see them, but we don't remember seeing them before.
And I'll admit, it is a bit hard to see under the loop, but the printed piece does show the striations, if there is a big enough single color solid. Albeit hard to see with the naked eye, very easy to see under a loop. Still should be acceptable, but need to look into the issue.
First question is, has anyone else seen this before? And how did you go about mitigating the issue?
Secondly, could we change the intensity of the laser of our Magnus 800 to overcome the issue?
Plate - color bar - under loop
Print - color bar - under loop
And I'll admit, it is a bit hard to see under the loop, but the printed piece does show the striations, if there is a big enough single color solid. Albeit hard to see with the naked eye, very easy to see under a loop. Still should be acceptable, but need to look into the issue.
First question is, has anyone else seen this before? And how did you go about mitigating the issue?
Secondly, could we change the intensity of the laser of our Magnus 800 to overcome the issue?
Plate - color bar - under loop
Print - color bar - under loop
