Hi
is anyone using Varn protector Fount solution?
Our incoming water supply ppm = 140 (interestingly enough our chilled water dispenser in the office reads 300ppm!)
Our fount mix @ 5% gives us a conductivity reading of 700µs in the tank
No alcohol used at all
Our pressmen are telling me that the ink seems to be emulsifying, we're not getting clean startups either.
We changed over from 8% alcohol using Varns' cleanup routine, we noticed an improvement in the amount of foaming (Tecnotrans Alpha fount chiller/doser/circulator) but the damp on press is as described.
Any input appreciated.
is anyone using Varn protector Fount solution?
Our incoming water supply ppm = 140 (interestingly enough our chilled water dispenser in the office reads 300ppm!)
Our fount mix @ 5% gives us a conductivity reading of 700µs in the tank
No alcohol used at all
Our pressmen are telling me that the ink seems to be emulsifying, we're not getting clean startups either.
We changed over from 8% alcohol using Varns' cleanup routine, we noticed an improvement in the amount of foaming (Tecnotrans Alpha fount chiller/doser/circulator) but the damp on press is as described.
Any input appreciated.