Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

Agfa LP68 Heating up problem?

Collapse
Canon
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Agfa LP68 Heating up problem?

    Hello,

    I have an AGFA LP68 Ultra processor. However, lately I get the error 4 1 (Heating up Problem). What is the reason for this and how can I fix it.
    We are located in South America and there are no technicians around who knows about this type of unit.


    Any help will be useful.

    Thanks in advance.


    Adrian

    Edited by: Adrian Juman on Feb 27, 2008 7:05 AM

  • #2
    Re: Agfa LP68 Heating up problem?

    I had this problem before. I my case the temperature sensor was covered in gum. Once I cleaned it off things worked correctly.

    From the operator side of the machine, look into the back left corner of the finishing tank, you will see what looks like "3 silver fingers" point down into the tank. These are the sensors.

    Comment


    • #3
      Re: Agfa LP68 Heating up problem?

      Those spikes are the level sensors not the heating sensor. Heating sensors have a flat end - part number 6 on the attached diagram

      Comment

      4OverStandard FinishingDuploSmartsoft (Presswise)AleyantCanonKBA
      Standard FinishingDuploAleyantCanonGraph Expo4 PeesLabelexpoKBAKBA4OverSmartsoft (Presswise)

      What's Going On

      Collapse

      There are currently 2751 users online. 45 members and 2706 guests.

      Most users ever online was 6,597 at 10:25 AM on 04-20-2018.

      Working...
      X