• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

Agfa LP68 Heating up problem?

AdrianJ

Member
Hello,

I have an AGFA LP68 Ultra processor. However, lately I get the error 4 1 (Heating up Problem). What is the reason for this and how can I fix it.
We are located in South America and there are no technicians around who knows about this type of unit.


Any help will be useful.

Thanks in advance.


Adrian

Edited by: Adrian Juman on Feb 27, 2008 7:05 AM
 
Re: Agfa LP68 Heating up problem?

I had this problem before. I my case the temperature sensor was covered in gum. Once I cleaned it off things worked correctly.

From the operator side of the machine, look into the back left corner of the finishing tank, you will see what looks like "3 silver fingers" point down into the tank. These are the sensors.
 
Re: Agfa LP68 Heating up problem?

Those spikes are the level sensors not the heating sensor. Heating sensors have a flat end - part number 6 on the attached diagram
 

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top