Could really do with some opinions here...
As you may have read from my past threads, I recently got a Xerox C560 with Light Production Finisher. I know it's not the best printer in the world but it's substantially better than my last machine.
Anyway, when I'm printing stuff, the printer doesn't seem to print in the same position of each sheet of paper. As an example, I might print an A3 poster (on SRA3 paper), and the first sheet might have a 10mm border on the left, and the second sheet might have a 14mm border (not exact measurements as I've nothing to measure at the moment).
This in itself is a right pain in the rear, but coupled with the fact I've just spent a lot of money on a Uchida BC-10 business card slitter, the problem is amplified somewhat as I have no control over where the cuts are.
Now, I'm always open to the idea that I'm the one at fault being a relative beginner, so I'm just wondering if it's me (or my expectations), or is it something I should be asking Xerox to come out an look at (or is there something on the printer I can play around with)?
Any suggestions gratefully received.
As you may have read from my past threads, I recently got a Xerox C560 with Light Production Finisher. I know it's not the best printer in the world but it's substantially better than my last machine.
Anyway, when I'm printing stuff, the printer doesn't seem to print in the same position of each sheet of paper. As an example, I might print an A3 poster (on SRA3 paper), and the first sheet might have a 10mm border on the left, and the second sheet might have a 14mm border (not exact measurements as I've nothing to measure at the moment).
This in itself is a right pain in the rear, but coupled with the fact I've just spent a lot of money on a Uchida BC-10 business card slitter, the problem is amplified somewhat as I have no control over where the cuts are.
Now, I'm always open to the idea that I'm the one at fault being a relative beginner, so I'm just wondering if it's me (or my expectations), or is it something I should be asking Xerox to come out an look at (or is there something on the printer I can play around with)?
Any suggestions gratefully received.