Recent content by Boneck

We have a similar curve on our platesetter… while we are not spot on as you are for the actual… the Target values were measured compare to "film" jobs that had saturated mid-tones (dot gain). When our platesetter was put in… we targeted it to matching the tonal "gain" of a film printed...

We have a Suprasetter 74… had the same issues with "random" scratches being applied to the plates. Our issue was indeed a mechanical issue. Scratches could be seen on the backs of the plates that you could visibly see… you could not see the scratches to the images on the plates until you put...

Zero it is. not bad for a 45 year old!

It sure looks like the paper grain to me...

Did you reduce the size of the photos in InD... InD would show you the "effective" resolution after the scaling which should reflect what you are seeing in Pitstop...

Everyone will have a different answer with different percentages... but we are able to run about 95% of our work on 24" material. Either buy the larger printer to be able to run what you need, or plan on outsourcing the larger prints.... just my opinion. We run 24" material on a 44" printer...

SheetWise... rather than tumbling the sheet, it is turning horizontally.

We have had it for the last 7 years... it performs well. What do you currently have? Are you upgrading or how are you planning on utilizing it as a tool to recover that investment? If you implement the prepress interface for passing along the ink key settings, it can certainly save you time and...

Ink Charge... if you change your ink charge on the units... will the horizontal bar follow?

you will need to set up prinect correctly... there is a check box in your imposition output device... sheet preview generation. Check the box that says Front and Back in one File. That will take care of it.

Sounds like Screen angles would be your issue... they are laying on top of each other when you are in perfect register... should be able to tell with a loupe if that is your issue. Change spot color to magenta angle.

I have not yet... been shutting it down when not plating.... did not get a chance to troubleshoot the fill sensor yet.

It is a G&J C85 processor.... can you tell me where the level sensor is located? thanks, Boneck

Any ideas on troubleshooting what relay may be out on the Glunz and Jensen C85 processor? As soon as you turn the unit on... the pump now runs continuously. Any thoughts? Thanks,

Gordo is correct... at the very least a laser proof indicating the change... and who and when it was approved.