Recent content by khouryabdo

Hello I have a sm52 -2 mod 1999 I can not get trouble free printing only if i set alcohol dosage to 20% in the dampening solution. Do it have negative effect as i know that alcohol should be set to 10%

how can i know if it is set to zero?

I mean the Operating side when i set it to the size the printing is not set in the middle of the paper , the drive side is ok the margin of error is only 1mm, but to the operating side it is 1 cm. About the servo drive where is it installed??

Hi i have a sm 52-2 mod 1998 i am having a problem with the left side guide it gives me an incorrect sheet size when i set it from the cptronic. Any remedies??

No i will check the the roller strips today and yes i am running integrated the application roller is engaged what is the effect of the integrated mode and why is it used for?

Yes sure Alcohol 10% and fountain solution 2.5%

yes i have a mac computer but never used facetime

didnt get it yet :S My email [email protected]

Yes the both units because i used the same roller settings on the both units and i change all the new rollers at the same time. so basically i have the same problem on the both units on the first slightly more sever from the second

after setting the dampening system as recomended by catalogue the get a very wet plate even the water speed is to low 10 or 15 . when i print i get too much water at first 200 sheets then suddently it begin scumming ( ink on non printable area). so in order to resolve this problem i was obliged...

what is the main function for the intermediate roller , application roller and when i should engage or disengage it. and if I'm getting ink on the water pan is it from this roller>????

One more thing just to tell you why i think i have a pneumatic problem the water is always high so i am obliged to squeeze all the dampening roller in order to get rid from the exess water so i can get good printing. but i think that this setting will affect my rollers life time because it is...

so i should put ink on the dampening rollers? And then do the test stripe? and between which roller exactly?

what do u mean by stripe the dampening roller?

Hello I a have an sm 52-2 . my ink and damping roller are totally new. the setting of the rollers are as recommended by manual 100%. I am having unstable ink water balance during printing. how can i know if it is a matter of air pneumatic problem.( compressor)