Recent content by nemo

That transporter failure could have been just caused by repeated power on/off. Could have been a failed firmware upgrade as well - it means the head does not communicate with the MCE board. If it does not go away with power cycles, try upgrading the firmware on the laser to at least version...

That is not banding. Replace hotlink and data cables.

Clean the encoder disk thoroughly. If that does not fix it you will need a new drum amp or motor.

No way to fix it - you will need another laser

the laser is the issue but not the focus - that is a 3.3v internal converter error If your lucky, it could just be the cable There is no Local 3 card in a Magnus 800.

Turn it off with the doors open. While off - flip the breakers at the back off/on. Turn it back on, then close the doors - always from the middle. The buzzer starts when the sensors are not tripped at the same time while closing the door. It could be a bad interlock board but also misaligned...

The problem is not the carriage It is the Z-stage - that moves the laser towards the drum >>stage >>stage init Do not play with all the commands you see with help - running stage install tfx will reset your values in set al and you will never get it running again without somebody qualified. The...

aluminum

That error had nothing to do with TMCE - you most probably made things worse and you may have the wrong firmware or missing nvs parameters now. wincore.cpp is from Windows itself or either corrupted OS or called incorrectly due to a corruption in application - should have reloaded BIOS, the OS...

Assuming punches are registered, you will need an engineer to look at your machine. Each plate type needs specific parameters adjusted in the laser - in your case the reflectivity may need adjustment. It is not a sensor - it is a laser beam supposed to detect the plate and track the plate...

I guess you meant 2.7 but does not quite work that way... You need proper SCSI card with proper drivers and the CTP firmware needs to match the rest of the software..

There is no such thing as a service manual for any Kodak CTP be it Lotem, Trendsetter, Magnus, etc... be careful about sharing your emails and what you download... There were some internal websites with lots of information (TechPlanet) that could be available on DVD's which are at least 5-6...

2003 server x86

Your problem is the PC controller - not with the Trendsetter - "power saving mode" is a message from the display itself meaning that there is no video signal. Have your computer guy look at it or call Dell for support using the TAG number.

you guys are too worn out by the system.... As a well prepared and hard working person I would have personally done the same and refuse an insulting raise plus seriously thinking of finding another job. It simply does not matter what your "policy" is. Don't treat people like slaves or tools...