Recent content by Phanx11

A good day to everyone Komori GS 228P has problem changing format (single to perfecting or even perfecting to perfecting size) machine would give an converting indicator error light and the position error is the top hook. Right now operator tried to change perfecting format. He followed...

No it's not, not even close, not that I have or wants kids to compare to. I would recommend people not make these comparison if your not a low level programmer or have understanding of fundamental IC principle and design. I'll explain in simple terms what your "AI" means. First of all...

Hi everyone I'm working on repairing a Komori GS228P. It's old machine and has been the victim of random repairs. The last one as they told me, the absolute encoder on cam by motor was replaced with exact same model (much newer sticker though) problem is, i checked old encoder and it works...

Hello Looking to buy 2 used but low hours laser diodes for Agfa Avalon N8-50 / PlateRite 8800III machine. LDL and LDU If anyone has to offer, please let me know.

It's NOT ok. Zoom must hold, just like on your camera lens it must be tight seal, not self wondering back and forth. Gear are worn in gearbox not motor it self. That's why there is backlash. You know i doubt we'd face so much trouble for month if we forgot to set media type to nega. But yes...

Found the zoom motor's gears are worm down, motor has enough backlash/free move that's equivalent to 200 pulses. From service zoom position manually, minimum allowed 210 pulses, backlash is same. See video: Ordered new zoom motor from Agfa, not to mention new turbofan. Old one had burned...

Hi everyone Client has old Agfa 8800MKIII that had tons of issue. Previous owner used machine for 12 years straight. After fixing both LD driver boards, power supplies, cleaning all optics and calibrating all motors etc... Machine works and prints well on positive plates (Agfa Elite pro...

We're in the Baltic states. Quiet the distance from PA. But the service manual is only a time saver. The machine is so simple reverse engineering it presents no challenge but it does take time.

Hi Looking for the service manual to the c.p bourg booklet maker and sheet feeder. Machine is experiencing strange communication issues between modules. Maybe someone can help. https://www.upload.ee/image/14172695/IMG_20220526_090936.jpg

Sent

Selling Agfa Avalon VLF micro chassis PCB's, power supplies, motion chassis drives and more. All taken from working unit, tested before decommissioning. List of parts: * CPU PCB (2pcs.) CG+0033740502 * Rotary servo board (2pcs.) CG+0033760501 * Linear Servo board (2pcs.) CG+0033770501 * SDX...

It wasn't about replacing but reverse engineering. Managed to do so successfully and figured out the input control and output feedback.

Hi everyone Got a question about the laser power supply board from an Avalon VLF (60 XXT): the board is controlled by the pelvis board, same that controls the GLV. There is only a 4 pin header connector (J1) between the pelvis board and the laser power supply that sets the laser current and...

Got a problem with an avalon n8-50, error E711d: "When the clamp is out, some tail clamps are detected on the clamp arm, or when the clamp is got, some tail clamps are not detected on the clamp arm" After the plate's been recorded the clamp arm lifts all the clamps off the drum, then the alarm...

Got both, thank you.