Recent content by rboyd

  1. R

    Need CTP Support for Creo Trendsetter New.

    We are looking for remote CTP Support and possibly on-site. We are located in Sedalia, MO. Thanks
  2. R

    Trendsetter - Unload Table Stuck

    CREO Trendsetter NEWS 2637 Autoloader All of a sudden the unload table is not working properly. The plates image fine, and exit to the unload table. The table goes down and the cups push the plate into the processor. But the table will not reset and automatically go back up. Just started doing...
  3. R

    Trendsetter News 2637 AL - Autoload Plate Picker Timing Out

    We attached a gauge and the vacuum is the same on the first and second attempts. The picker bar moves up and in to the same position on both attempts. The only visible difference is how the picker wrist approaches the plate. It quickly snaps against the plate on the first attempt, and moves...
  4. R

    Trendsetter News 2637 AL - Autoload Plate Picker Timing Out

    There are no slip sheets. Thanks for the idea
  5. R

    Trendsetter News 2637 AL - Autoload Plate Picker Timing Out

    The Problem: The plate picker bar moves up into position, vacuum turns on and it runs for just over a minute without picking a plate. After a minute, it times itself out. The bar will then do a slight reset and re-position a second time. It then picks up the plate as it should with no problem...
  6. R

    Print Console on another workstation

    I was able to install Print Console 4.7 on a new Windows 7 station, but I am getting an error that it is unable to open SCSI link. Message attached. Any ideas? Thanks.
See more

PressWise

A 30-day Fix for Managed Chaos

As any print professional knows, printing can be managed chaos. Software that solves multiple problems and provides measurable and monetizable value has a direct impact on the bottom-line.

“We reduced order entry costs by about 40%.” Significant savings in a shop that turns about 500 jobs a month.

Learn how…….

 
Back
Top