Recent content by [email protected]

Hi Frieds, I have some spare parts kodak and I want to sell it as a package. my offer is 50% off from the list price. REPUESTOS KODAK Unitario CODIGO DESCRIPCION CANTIDAD US$ 503D27353 STROBE 5 1 UNID...

tries to run the resolution test it is like focus or laser calibration. if you use positive plate, checks the entire system load (rollers), if they are dirty, it scratches the plates and these lines can appear in print. Good Luck, YR

Hi mrltechservices, Kodak does not sell that solid relay as a spare part, they just sell the control distribution board, but as Pach says you can get the relay localy, if not you will have to change all Power Distribution Board. But if your Magnus is a Magnus II and you have the same problem...

Follow the Pach recommendations and if the error continues, I recommend replace the drum Driver board

Yes, as kala said, Clean the silver sticker on unloading side else check the sensors...try to load a plate manually and unload it the same way, do it many times, and if everything is ok, I would assume the problem is a sensor that sense the gripper bar. Check your air pressure.

Hi Nemo, You are right but the shutter gets stuck sometimes and sometimes does not open or when CTP is exposing, the shutter closes before finishing, for that I told to Kala that try to do focus cal reflect and try to listen if the shutter open and close 9 or 10 times. But like you , I think...

Hi Kala, There are many possible causes: 1.- You need to replace the cable data ( it is like a fiber optic cable ) too. 2.- did you replace communication cable ( I guess it is SCSI ) between workstation and Trendsetter?, if you not please replace it. 3.- I suppose that you check the ¨Focus...

Re: EVO: making one separation wrong-reading? Hi,,,,,if you are usig a Magnus or Lotem CTP ( I do not know how is with another CTP) .......you need to erase the actual template and create a new template Cheers. YR