Search results

Now, the drum stops even when it's exposing plates. I mean , the plate is being exposed and the drum starts to slow. Only after the drum stops and i open any cover, i can unload the plates on drum. I don't think it's the encoder because the speed it's showed fine. The ctp just looses control...

I have a problem with a Creo Lotem 800V2. Randomly, when the exposure is at the end, the drum don't stop so that the plate can exit. I mean, in normal operation, the drum stops in about 2 seconds. Well, randomly, the drum stops after about 5 minutes and because of this i get an error message. Is...

How do you send jobs to Brisque ? I use Brsique 4.1 and i use the FTP server. I've heard that there is a method with a TCP/IP printer? Any one knows how to configure it ?

There is a separate volume for Brisque where jobs are stored. Can you tell me what to delete from the /usr ? There are some temporary files that i could delete ? Can you tell me exactly where is that defragmentation routine ?

The /usr DataVolume is 87% occupied. Is it bad ?

Is there any maintenance procedure for IBM AIX 4.3.3 that i should do regularly ? Something like disk defragmenter or scandisk in Windows. On this computer is runing Brisque RIP 4.1.

You are right, i have to call someone to change them. Thank you for helping me.

Do you know the size of those spings ? I want to buy them before i dismantle something.

Maybe i cand find in the manual a way to tight those grippers. I don't want to disassemble the whole machine.

Do you have a repair manual for this platesetter ?

The grippers are not holding the plate very tight. Because of this, air is entering under the plate and i have unexposed areas near the grippers. I am looking for a way to tight those grippers to hold the plate better.

I mean the clamps that hold the plate in position. Is there any way to adjust those ? Buying negative plates is not an option because the processor is for positive plates only.

Is there any way to adjust the grippers ?

Rotation is canceled in expose template.

So there is no way to get rid of this rotation ? It takes abous 3 minutes to rotate or whatever it does although i make the rotation from RIP.

What is a rotation board and what does it do ? Can i dezactivate it to speed up the RIP process ? I use Brisque RIP 4.1.

Yes, along the lead screw. Lotem aplication shows me that i have 3 mm offset in length and 10 mm on width.

This is the width offset. But i also have a lenght offset. What parameter is for this one ?

What magnets ? Where they are located precisely ?

At my workplace i have a Creo Lotem 800V2. When i load a plate on the drum i receive the following message : "The gripper is not on position". Anyone know what's wrong with it ?