Search results

Have you talk to Tony Stahl at Komori? He can talk to the resident Japense engineer if needed.

Usually the the manufacture of the lamps will set you up with a demostrator. Air Motion Systems are very knowledgable 303-277-1162 419-609-7371 Old phone #'s should get you started.

Do you find greater success outside the 3.9-5.0 window? Your measurement is only as good as the calibration of your ph tester. I find some meters lose calibration quicker than others, the press guys are not great at taking care of the device either

The magentic valve could be the issue, the lithrone was either the valve or the bolt would break on the mecahnical linkage on the operator side. LS, take the catwalk step off between the units and fire the valves manually

Has anyone purchased replacement IR/UV bulbs from Southern Lamps out of Florida? or used them for servicing their dryer units ? Thanks in advance

Speed Comp. Speed Comp. Erik If you have run a press with conventional dampners it is easier to understand the methodology. Some old press guy may also be able to help.

Zero Set Zero Set We use the KHS. 2007 machine. We run a wide range of stocks so the biggest challenge is selecting the right table for the substrate. Using the uncoated table on a coated sheet is the biggest error. The guys are good about keeping them cleaned and greased. You really have to...

Zero Zero You will have to set what micron works best for your shop. Start at 10 M, if your using the block guage the guys will get different readings.

Zero set Zero set We use the Erichsen Model 234/R1. 0-25 microns for zero setting. Cost about $ 800 us I ask the crews to zero at least 1 fountain per week. The rolling average keeps the preset close.

Oxidizing Inks Oxidizing Inks We use Toyo. "TSP" Toyo Special Product works well under most conditions, Speedy Dry can be added to make it quicker if needed but becareful.

Rollers Rollers We use Graphic Roller. Kevin Herger 303.358.6500 He has multiple rubber grades for different presses and budgets.

Weko Weko Weko are very friendly, call the tech. 516.885.0629 Know which unit you have! We have a 262, you can change all your parameters on the touch screen. 21 is the password in the service menu.

Looking for info on possible a print shop opening or relocating to Colorado. I was told 850 KOA radio metioned something on the radio? Have friends in Colordao looking for work. Thx

Talk to your blanket manufacture, Squeeze/Release is a big factor with Strike Through and other gloss /dull combo's

Any suggestions on the rigging protocol for a Heidelberg cylinder die cutter? We have moved presses before but are unfamilar with this machine we purchased. Lifting points? Jack points? Do's & Don'ts? Thank you in advance.

G7 Techna print, 99% is a great number. What do others see on average? job to job. How many different curves are required? How many different presses run off of the same curve? How many different papers are certified? Thanks

How does a Pre-press dept. decide which proofing paper to use and if a background tint is needed on the proof? P.S. I work in the pressroom, keep it simple. Thx

Advanced Print Technologies Fred Goldwyn East Providence, RI. 302.761.9905 We bought a 40" press from these guys. Honest and experienced.

IR IR Output % will equal IR wave length. We like 30 % --70% for a short wave length. Some auto modes can be problematic with dirty sensors and sensors being out of calibration. Good operators should be in tune with this. Track your bulb burn hours if possible.

Cold Ink Cold Ink We had to keep a complete ink set on top of a 150 KVA transformer. It was enough warmth to get us running and the ink would flow