Search results

Practically, that's the best way to go. It's an old machine, new spare parts are not available any more. Used ones are hard to come by and/or hard to ascertain they are still working. Good luck.

"...it's my short term strategy sir, until I earn their full trust..."

"...oh, I see... If it's such a valuable box that is actually a collectors' item - I suggest you insure it appropriately and deliver it in an armored truck..."

We never had to resort to anything that drastic. Aligning the detector usually fixed problems. BTW, turning off the punches altogether may probably be done in the registry but I don't remember details.

Yes, you can do that via the Lotem software, but it may be easier to just unplug its' power cable.

"...and if you don't find the exact mistakes you made or want to learn how to avoid them in the future, please don't hesitate to ask advice from our team of expert pre-press operators. We shall charge only for the actual time spent..."

"...still, we don't recommend eating shredded prints as noodles or mixing them in salads..."

"... and this button is about to blow the fuse!"

You may find most of the answers here: https://workflowhelp.kodak.com/pages/viewpage.action?pageId=29501300

This control wedge is OLD! It was created for the old Taipan rip, for evaluating and calibrating film output from the imagesetter at 1200 dpi. Is that what you want it for?

You may find this site usefull: https://www.templatemaker.nl/

Most of the chemicals released to the room air will be released when the processor is working. The more it works, the more unhealthy substances get to the air. When the processor is inactive, it is likely that some chemical substances will still be released to the air, depending on how well the...

Oh,,,, How about we step back and send you a shipment of the former plates, those that you were quite happy with?

Working daily in a 12x12 room without ventilation? That sounds like a health hazard already! Processing chemicals for films/plates are certainly adding unhealthy substances to the air. How harmful? - that depends on the combination of volume and type of the specific materials and chemicals...

I have a good, tested, working SOMC card. If you want it - PM me.

Thanks Scotts, This material seems amazing. It's not cheap but probably worth it. I wish I knew about it before...

Send me a PM with your email address, I'll send you an image. Also, write the type and part number of your OMC/HOMC/SOMC card.

1. At this state can you enter into Utilities/Tools Operation/Diagnostic? 2. Do you have a Diagnostics diskette?

You may use the Diagnostics Program to help. On your Dolev 800V2 it should be installed and accessible under "Utillities" or you can operate it from the diskette.

Check for the error message using the "Show Errors" function and act according to the relevant error. To access the "Show Errors" function: a. Pressing F1 (until) on the operating panel b. Select "Show Errors" using the arrow c. Press <Enter>. NOTE: Return to "Standby" by Pressing <Esc> twice...