Search results

And how do you connect Galileo to computer right now?

SBR - Single Board RIP During boot-up process Accuset will try to establish contacts with RIP, which is on-line yet. From AGFA Field Service Bulletin: Question How do I clear a 20 SBR error ? Answer Most SBR errors are due to an improper bootup sequence of the Accuset and RIP. In this...

OK, just try direct output HQ RIP -> Galileo But we don't know what your dongle is for: Prindrive or HQ RIP?

So, you did not use your Galileo yet. Right?

Correct, you need 7.5 kW stab in that example

Normally that's a "calibration target" file for visual control of different parameters of CTP. For example: AGFA uses DigiControl Wedge file. Ask Krause what file they have or recommend to be used for that purposes.

LP 82 Ultra plate processor needs 3 phase power line normally, but there are a few different possibilities to be connected to single or 3 phasse 220, 380, 400 Volts. Look at the diagram inside the electronics comparament. Make a calculation of total current Amp value from all connected devices...

Print Drive allows you to do a rasterisation of the job via non-AGFA RIP and send data to output device, even to proof if that option is open in the dongle. So, you have UPAC APIS board installed in your PC, or you have HQ RIP board for direct RIP -> Galileo output, if you don't use PrintDrive.

It's in here on site. Use Search option.

If you decided to keep DEV and FIN, try to use flexible plastic bags or cans - to remove exessive air off. But after that, in a few days later, when you want to refill the processor, you have to simulate a maintenance mode or cycle, because of smart LP processor will calculate the time of beeing...

Azura is a brand name of plates. Do you mean Avalon N8? In this case your machine is OEM Dainippon Screen. Try use that name for web searching. Good luck!

99% that's a film aging problem. As well as bad maintenance of the film processor. New roll of film, clean processor, fresh chemistry, internal Accuset test for optical density finding, real job imaging and processing - after all I'll be ready to talk to you.

Your quick shot did not give me useful info to help you. Out of focus, bad magnification, no info of fast/slow scan direction. You'd rather scan film than use phone or camera.

You a not the only one person who fixed that problem by the same way. Glad to make mormones happy! :) Best regards! Vladimir

You understand incorrect. This strip (DigiControl Wedge) to be used for finding proper exposure level of CTP. Depending on the type of plates, 1X1 or 2X2 field should be invisible (matched to background). If you see some targets lighter than background - overexposure. Darker - underexposure. So...

OK, that's full description how to solve this problem. See attachment.

IMHO anyone of 3 main players (AGFA, Fuji, Kodak) on the market of prepress equipment would be glad to pay some money for such a kind of information.

Replace it with the same value (or higher) voltage/capacity parameters capacitor and be happy. Your capacitor is completely dry and dead now.

MOlja, bratushka!

Something wrong with focus parameters. You are out of focus at 0.15 mm plates. It's just a thought.