Search results

Hi if by any chance anyone has operating manual of Nebiolo die cutter -anymodel will suffice- Thank you in advance

Go to Utilities>Hardware>Punch system>Punch system i think you can turn it off from there or try Utilities>Hardware>Loading system>Loading system>Select punch for loading, hope that helps

So CtP are installed totally blank and techs make TH sets according to plate(s) used in house, sadly this machine has no official service and have to rely on techs that are very few in our country -as far as i know- or do it yourself and cross your fingers

I see...i guess the default TH set name is somewhere saved?

Thank you for replying Alois if only i knew where to find them...

Hi i am using the beforementioned CtP for exposing waterless plates -Torray/Presstek- for GTO52 DI and want to try conventional plates without tampering with laser power at all. I presume analog plates will not work so thermal CtP plates are needed right? Want to learn about processless too...

Did you try printing only 7488 and lowering dampening till it scumms? Switch units and sequence?

Dont know if that helps, let ink form rollers oscillate, could be ghosting

Isnt it possible to "develop" processless plates out of the press, with automated plate developers? -instead of chemical baths to water-

It looks like fibers in 80% are you certain about same supplier/batch of paper?

Is it possible to make a web growth compensation in the form of an inverted smile in Prinergy 5? If yes care any one to tell me the commands in the file using commands xpansion/xyshear/rotation/xyshift. On my magenta unit 4 corners of sheet are in register but moving towards the middle of the...

Hello does any one have any info/manual on how to set Aquaprint rollers (width of stripes on plate/oscillator) on a GTO52? As far i see there are 3 rubber rollers (metering, transfer, form)

There are a whole list of things to check: Ink form rollers to plate/oscillators Calcification of rollers New blanket Packing of blanket Ink with more tack -or increase current ink`s tack- Dampening fountain temperature Proper development of plates A few pointers to get you started hope that...

Did you resolve your problem, was it mechanical or not?

Seems like the press does not throw off impression, there is a switch OS that you turn on to put the plate are you certain that is not switched on, check your blanket with packing to be .005 mm under or even with bearers else its a mechanical problem, my 2 thoughts at your disposal

I suppose production room is in a stable temp/environment? After you wash blankets run her with rollers on for say 1 min to heat up and see how that goes or at your break leave at crawl speed -unless you do that- not stationary Btw have you changed towers? say K to 2 etc?

You wash blankets by hand or auto? Try wash by hand and dry thorough blankets -unless you tried that of course-

Money a lot of people hated, glory on the othe hand none :)

Try printing one color at a time or in combinations -KC, KM, KY- and check your registration from tower to tower it could be transfer grippers, also try feeding paper with no impression and do a sudden stop and try to pull the sheets from transfer drum at each tower, perhaps you might pull paper...

So spectrophotometry is useful, after the job is printed? :)