priyantha mudalige
New member
i got used Riso HC 5500 machine for my printshop its with cable lift system
it gives errer S03-250
when i refer technical manual its cause not moving PB spacer properly to left end
i check the machine then i noted the dilivery table is beyond its top level so BP spacer dont move through the shaft from the print head housing
so anyone please let me know how to adjust its top level a few mm distance down
thanks for your kind assistance ..
priyantha mudalige
NEW ROYAL INTERNATIONAL
SRILANKA
it gives errer S03-250
when i refer technical manual its cause not moving PB spacer properly to left end
i check the machine then i noted the dilivery table is beyond its top level so BP spacer dont move through the shaft from the print head housing
so anyone please let me know how to adjust its top level a few mm distance down
thanks for your kind assistance ..
priyantha mudalige
NEW ROYAL INTERNATIONAL
SRILANKA
. I know this may not be the best place to post but i really need help connecting the Riso gr3770 37 pin to SC7700. So i dont have a cable and i wish to make one, the 36 pin plug that goes to the SC7700 is is easy to find and i will wire it directly to the 37 pins in the Riso but i need wiring diagram for those pins. If anybody has such a cable could you please test it and let me know how the pins in the cable are connected?. thank you so very much for any help 
