lyzan
Well-known member
We changed the power panel of our Polaris XTV because for some unknown reason the digitizer was broken. Prior to the broken digitizer, the digitizer suddenly became unresponsive to touch.
Just few days ago, a new power panel was installed. But the same problem exists, that is, digitizer is not responsive to touch. As a result, we cannot shut down the machine via the power panel. So we are using the emergency stop to load plates. We use the same compact flash from the old panel for the system.
Anybody encounters the same problem? Is this a software problem? Do we need to re-calibrate the touch screen? If so, how?
Thanks,
Lyzan
Just few days ago, a new power panel was installed. But the same problem exists, that is, digitizer is not responsive to touch. As a result, we cannot shut down the machine via the power panel. So we are using the emergency stop to load plates. We use the same compact flash from the old panel for the system.
Anybody encounters the same problem? Is this a software problem? Do we need to re-calibrate the touch screen? If so, how?
Thanks,
Lyzan