Antique proset 9400

[EPS]

Is it possible to adjust leading(film feed amount) from the keypad of 9400? I replaced main film feed roller(rubber bad) with one that I had recovered at a roller co. Since then, an 11"x17" job feeds about 1/16" to much.(1/16" to long) Would that procedure, if possible, be in the operators manual?

 

[VladCanada]

Nope...
That's a Service procedure described in Sevice manual at Capstan roller replacement procedure chapter.
There is no pdf files available worldwide, just printed booklet (and I lost mine probably somewhere
in prev. century )