hartmutdau
Member
I just came back from Egypt where I installed a PRIMESETTER102 to an existent XITRON / Harlequin Blue Box (vers. 8.1)
This RIP has worked and still works fine with another PS102. But when the RIP is connected to the "new" Primesetter
there is always a black solid line (appr. ,3 mm) exposed underneath the job. The line comes in Slow Scan direction and has a distanceof appr. 5 mm to the job. Theoretically it can just be cut. As I said, the line comes only with the "new" machine. When I connect the Primesetter to an DELTA RIP, there is no black line. That makes it quite confusing.
Has anybody faced such problem?
Thank you
best regards
Hartmut
This RIP has worked and still works fine with another PS102. But when the RIP is connected to the "new" Primesetter
there is always a black solid line (appr. ,3 mm) exposed underneath the job. The line comes in Slow Scan direction and has a distanceof appr. 5 mm to the job. Theoretically it can just be cut. As I said, the line comes only with the "new" machine. When I connect the Primesetter to an DELTA RIP, there is no black line. That makes it quite confusing.
Has anybody faced such problem?
Thank you
best regards
Hartmut
