We switched over from Kodak to Fuji.
The plate are different sizes. Kodak 1029 Fuji 1030.
We use to use auto to send the plates. If our setup was wrong
we would get a error; the machine wouldn't take it.
Since they switched us over they over rode that, now we don't get the
error. It will run a smaller setup with the wrong gripper.
We want to get back to the error message.
Now, in the machine you can change the horizontal positioning but its not working.
It didn't effect it at all. The image needs to move 1.1 mm
Has anyone figured this out? Or have any other incite?
thanks
PlateRite 8100
TrueFlow 4
The plate are different sizes. Kodak 1029 Fuji 1030.
We use to use auto to send the plates. If our setup was wrong
we would get a error; the machine wouldn't take it.
Since they switched us over they over rode that, now we don't get the
error. It will run a smaller setup with the wrong gripper.
We want to get back to the error message.
Now, in the machine you can change the horizontal positioning but its not working.
It didn't effect it at all. The image needs to move 1.1 mm
Has anyone figured this out? Or have any other incite?
thanks
PlateRite 8100
TrueFlow 4