Recently the developer has been foaming up in our Glunz & Jensen (CTP) plate processor. I'm curious if anyone else has had this problem in the past and if there are any solutions to it.
The plates are currently not getting any spots on them, but the tank isn't being topped up by the replenisher as much. The sensor seems to be covered in foam most of the time, which of course fools the processor in thinking that the level is still sufficiently high....
Thanks!
The plates are currently not getting any spots on them, but the tank isn't being topped up by the replenisher as much. The sensor seems to be covered in foam most of the time, which of course fools the processor in thinking that the level is still sufficiently high....
Thanks!