Hello everyone,
I have a Duplo DC-10/60 System 4000 collator tower with the following details:
Touch panel: Mitsubishi F940GOT-LWD
Firmware version: 11A-80105
The machine was not used for a long time. After installing a new battery, the touch panel shows only "DATA IS NOT FOUND" on startup and the machine cannot operate.
Has anyone experienced this issue before? Who should I contact to get the touch panel restored – is there a specialist or service center outside of the official distributor network that could help?
Any advice would be greatly appreciated.
Thank you
I have a Duplo DC-10/60 System 4000 collator tower with the following details:
Touch panel: Mitsubishi F940GOT-LWD
Firmware version: 11A-80105
The machine was not used for a long time. After installing a new battery, the touch panel shows only "DATA IS NOT FOUND" on startup and the machine cannot operate.
Has anyone experienced this issue before? Who should I contact to get the touch panel restored – is there a specialist or service center outside of the official distributor network that could help?
Any advice would be greatly appreciated.
Thank you
Last edited:
