• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

Edge detected beyond the begining of the plate Lotem 400

moncivaez

Active member
Hi. Working with Lotem 400 .

The first exposition of the plate is correct. In the second exposition this error appear:

"Edge detected beyond the begining of the plate". Some problems with laser appear too.

Reset the machine and again have success with the first one. The second can not be exposed

I cleaned almost everything I think.
Sensors, Strip, Drum, holes.

Please someone could give me some advice about this problem.

Thanks on advance.
 
I want to share the solution to this problem.

A sensor of the motor carriage, in the right part, was changed .

A DDL card (The laser controller card), the number 0, was changed .

The technical service informed us that the diode 0 is the one responsible for the edge detection.

I hope this solution help whom experiences it .
 
This a problem is the surface of the plate your need calibration the edge detector in the lotem the lotem not looked the plate surface
 

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top