Scott in CA
New member
I developing film output from an Agfa Accuset 800, in a Glunz & Jensen Mulitline 15 processor and my film density is too low. I have the exposure set as high as possible on the imagesetter (255).
I've addressed all the possible causes in the processor's manual:
- exhausted developer - mixed a fresh batch
- developer too cold - increased temp of developer
- developer time is too short - increased time
- replenishment insufficient - increased values
We normally mix the developer in a 1:2 ratio. Would increasing the ratio yield more dense film?
Any help is appreciated.
Thanks.
I've addressed all the possible causes in the processor's manual:
- exhausted developer - mixed a fresh batch
- developer too cold - increased temp of developer
- developer time is too short - increased time
- replenishment insufficient - increased values
We normally mix the developer in a 1:2 ratio. Would increasing the ratio yield more dense film?
Any help is appreciated.
Thanks.