Metadimension and Epson 9900 with Spectro

[zoran]

Anyone with same setup?
Is it possible to utilize 9900 Spectro to check every proof and "certify" it.
It is offered by most of the third party rips but I wanted to drive it directly from Meta without third party rip.
Everything works fine but I can not figure out if this is possible.

All I need is to measure every proof and put "Pass" or "Fail" if it doesn't scan properly or something similar.

Any help is appreciated.

 

[toronar]

Metadimension 2012 with ColorProofPro 4 in combination with Prinect 2012 can do that.
At least that is what was shown at the Prinect Userdays in november.

 

[zoran]

Thanks, I found out that in next service release SR1 we should have that functionallity.

 

[chevalier]

This is why I bought an ORIS RIP with my 9900. I'm done with fooling with HDM being so far behind in this area. The EFI software HDM licenses has had the functionality for a long time yet they are just now getting around to integrating it.