need help about colormunki

[yyu]

I have a large format printer twinjet, running on iprint 3.0 rip software/control software.
I want to calibrate the outfit thru colormunki, but I cannot see the twinjet attached. But I can print thru the twinjet rip software. Saw in some articles that you do printer sharing in order to this. Any advise

 

[Lukas Engqvist]

Sorry you aren't seeing any answers. You may want to check your manual again.
If you are printing through your RIP then your calibrate.
Normally a calibration will be Print a test chart with unmanaged colour using your standard work flow.
Read the calibration charts with your measuring device (colormunki)
Generate your ICC profile. You will either apply your profile in the RIP, but could be that most likeley you will apply it in your software either as an output profile or, if you are proofing as a proofing profile.

Hope this will set you in the right direction. (I think in this forum most users are using higher end equpment for colour management, I myself am a little curious and would like to have a munki, to evaluate it's usefullness but there is a limit in my budget as to how many photosectrometers I am allowed to buy)