Prinect 2010 - GMG ColorProof

[2Night]

Hi All

We've recently installed GMG's ColorProof to run the proofing side of our workflow.

Is there anybody out there that has a similar set-up and if you have are you sending 1-bit tiff's to ColorProof?

We're keen to do this in order to make sure that the proofs are being produced by the same RIP as the plates.

I was just wondering what is the best way to create the 1-bit tiff's. I have got something in place but would be interested to know what other people have done.

Phil

 

[RodrigoRocha]

Hello!

We use ColorProof here too, but it goes throw ColorProof, where we print the proof after; and then we send it to the RIP, to record the plates.

 

[zoran]

Why not run Meta, same vendor, same workflow, same APPE that renders plates.
We've been using Meta for 7 years and it always perfectly matched plate output, never disrepancy.
1-bit tiff to proofer is waste of time and overprotecting if you ask me.