Still having clamp issues with printmaster qm-46

[TLawrence]

The plate clamp to release the plate gets stuck in the middle of qm-2. The left side and right come out fine, but the middle is stuck so the plate breaks off and I have to dig and dig to get the rest out. Is this a air pressure issue? The gauge for the air is always below or high in the red, never in the green. Any ideas? I can't keep burning new plates all the time.

 

[RGPW17100]

Check the spring on the gear side for the plate eject. It should be 5 mm.

 

[inky]

Check the spring on the gear side for the plate eject. It should be 5 mm.

Mine snapped tonight.

 

[TLawrence]

How did you get it fixed if you did?

 

[inky]

How did you get it fixed if you did?

I ordered one from Heidelberg, it´s only one Allen bolt to fit it.