Recent content by color_prepress

I found out the problem, 1 of the PH25 sensor which model is FSV21R the preset value lower than current value. Raise the preset value more than current value then it can work. Don't know why suddenly the value can out as it had use so many year without problem. Thanks

I found out the problem, 1 of the PH25 sensor which model is FSV21R the preset value lower than current value. Raise the preset value more than current value then it can work. Don't know why suddenly the value can out as it had use so many year without problem. Thanks

Last few day it gives this error after it unload the finished imaging plate and start loading the new plate to prepare for imaging. If I only load 1 plate and not put 1 more for standby into machine, it work ok. Today even I just put 1 plate and not putting 1 more for standby, it still cannot...

Last few day it gives this error after it unload the finished imaging plate and start loading the new plate to prepare for imaging. If I only load 1 plate and not put 1 more for standby into machine, it work ok. Today even I just put 1 plate and not putting 1 more for standby, it still cannot...

If I found the solution then I no need to ask at here.

Machine is Platerite 8300 I get that error code. I already restart/reinitialize the machine and now it work but I don't know will it happen again. Anyone know what is it?

Here can't find the 3d printer supplier. ChrisZ says it is easy to make with file, sandpaper and piece of hard plastic. How to do it with that?

How to DIY? As you can see from attachment. It is cracked and now it is not able to push the lock so I always have to manually open it.

what is the name for this? Can I find it online?

My Screen PTR 8300 door lock unit got problem. The white item in at my place got crack. What is the name for that? Is that possible to find a replace just for that rather than motor? My motor ok, just that white item crack only.

ok, finally found out the place. After clean at there, it able to work. Thanks

Right side? you mean got touch screen side?

Can you show me the photo/image for that? I not very clear which part of it at there. I search website and service manual also cannot get a image on that.

Thanks

Today I tried from 670x560mm then 525x459mm then 510x400mm. It load and balance normally. So I think what Pabney say is correct to what I facing. Maybe most of the time when it from 670x560 to 510x400, it hard to balancing but I don't know why there is no problem when 670x560 to 525x459. Seem...