Recent content by DigiRod

Don't need it on the quote letter or any report. Need the total weight to get out FOB shipping cost.

Looking for some extra resources. We do work with Pace on issues at times. Ran into one today where we had 6 parts and wanted to get a total weight for shipping. We have our cartons in Pace with a max weight per carton. When changing the operation level to "Product" or "Estimate" it does not...

Any Pace guru's out there in the estimating world?

Busy holiday season.... Thanks for all of your suggestions. I will keep these in mind for my 9210. We're waiting on our 9500 to come in very soon....can't wait!!!

Folks, looking for some help with a print quality issue on gloss and silk stocks. In my solids or builds I start getting a mottling issue. I've attached a picture for reference. Ricoh says to lower the temp of the fuser, that its pulling the coating off the sheet and relaying it down. I have...

Thanks for the tip. I will have to check these out. I have a pretty good tech that works with me on things, plus the machine is 5 yrs old with a hugh click count.

I been running this the past couple months with little issues and now I can't seem to get multiple sheets through the press without the static causing it to stick to the cooling belts just after the fuser. I'm able to print 1 sheet all the way through just fine. I would have thought over the...

When printing job in duplex one side prints nice while the other goes to crap. If I just print one side that side prints crappy. I've played with the transfer voltage but haven't had any luck. Any help or recommendations appreciated. Thanks!!

Curious what you find out. We changed out our iJet Classic for the NXT back in January of this year. My consumable prices weren't so bad but I was informed they will be going up.

printing 656, if any tech told me.... 'that's within spec', I have to agree with PrintIT. He would be shown the door and taking his machine at the same time. I usually hear the standard... Its your temp. and humidity causing the issues. Our registration has always been very good with acceptable...

Having issues with my front to back registration drifting 1/16 to 1/8 while printing. It also seems to come and go and is not consistent. Secondary Transfer roller and also the gray roller just before the transfer roller along with both sensors have been changed and cleaned. Any help, advice or...

Everyone is commenting how good they are running envelopes with quality near offset but what about bleeds?

Thanks for all the info. Its nice to hear what others are doing and see I'm not doing anything different. My thought when I posted this was does anyone go through the service menu to reset/calibrate the patch sensors or drum sensors to achieve a better more consistent color calibration?

Hello all, Was hoping to see what steps others are doing in their morning startup regarding color calibration. Right now we follow the steps we were told at the beginning of installation which was to check lens, grids and then do shading correction, run full Auto graduation, then print 34 patch...

Erik, Glad I was able to help. Do you take in any Sprint Car racing out there in Ohio?