Recent content by GypsyDriver

All was going fine a couple of weeks but suddenly, I get very poor quality specialy with the text. the fonts looks like i'm printing with a 72 dpi file. We can see the stairs with the naked eye. The tech has been here for 2 days, change the head and made calibration and all kinds of reset but no...

Hi guys. I'm will be looking at a used ipf-9000 and I would like to get your advice as to what to check out before I make an offer. Thanks for any replies. Danny.

Hi guys. Anyone know about these printer/cutter How they work ? What are these roll of colours? Thanks

Thanks for the tip. I'm just looking at the price and it is very attractive but, will it do other stuff than bus. cards? it's not 1/2 price from the Duplo but it is 1/2 of the Aerocut. Danny.

Thanks for the quik reply. What I worry about is the thickness Most of the cards I do are on 14 pt card stock + 1.7 mil laminating on both sides so, I get to almost 18 pt thick.

Hi everyone. I'm looking into getting 1 of these finishing machine and I would like to get more informations from a user, if there's one around here. - Therm-o-Type, ZIP A3 family - Duplo DC-615 - MBM Aerocut I had a demo on the Aerocut and it surely got my attention, for a small 2 guys shop but...

ZeeBee is right, I run it through drawer No. 5, not more than 200 piles. You do have to trick the setting but not that much. If you stock is 4 mil thick, on an enveloppe there are 2 layer of paper so, you set it as an 8 pts. Put the air setting at strong, not ''auto''. I was never able to run 9...

I almost went for a 9075 but, at the last minute, I changed my mind and went for a KM 6501 pro. From what I heard, I think I did the right choice. I have over 700,000 colour clicks and 200,000 black in the last 18 months. It realy gave me what I expected. I run anything from 20 lb bond to 12 pt...

Oups, that might be costly... Hope your'e covered.

Hi Emtri It happend to my twice in the last year or so. I just restart the computer and all was fine.;) Gypsy (Danny).

Hi. Iv'e been using CS4 on my PC with windows 7 for abour 10 months now and for the past week or so, I have this problem. When printing or saving, the PC hangs and gives me that little window with the not responding message. I wait and then it goes away and comes back again. It take 2 ou 3 tries...

I agree 100%, good choice. I also calibrate every morning, as I wait for my first cup of coffee to drip. :)

Rhonda. Thanks for the informations. I knew that the C900 was a good choice but up here, in the very cold country, and with the exchange, the C-900 is aproximatly 30K more expensive and since my budget is a little tight right now, I think I will go with the 9075. BUT, nothing is done right now...

Hi Craig. My production is around 50,000 sheets, 12 x 18 on 2 sides so, 100K full size. Coverage will varie from almost nothing to almost full. 80% will be in colour and 20% black. 60% on 8pts or 10pts stock and 40% on offset or bond paper. Also some NCR stock and labels. If production goes up...

Bonsoir Quebec. Oui, je suis aussi francophone :) de la rive Nord de Montreal. Je t'envoi un courriel a l'adresse mentionné. A bientôt.