Recent content by tzurko

I purchased a Xante Enpress new with enterprise feeder. Worst business investment/decision I've made. It's been a struggle with feeding envelopes for two years owning it. I've replaced sensors, boards, adjust belt speeds, raise/lower the feeder wheel, etc. - and added a new brush wheel kit they...

I purchased a Xante Enpress new with enterprise feeder. Worst business investment/decision I've made. It's been a struggle with feeding envelopes for two years owning it. I've replaced sensors, boards, etc. - and a new brush wheel kit they recently came out with. I had a tech install it...

've had the Xante Enpress since August 2019. If I would do it all over again - I would purchase the Intec Envelope Press. Their feeder makes sense and I've heard that another printer recently switched from the Xante Enpress to the Intec and has already run over 100k of envelopes thru it. The...

've had the Xante Enpress since August 2019. If I would do it all over again - I would purchase the Intec Envelope Press. Their feeder makes sense and I've heard that another printer recently switched from the Xante Enpress to the Intec and has already run over 100k of envelopes thru it. The...

've had the Xante Enpress since August 2019. If I would do it all over again - I would purchase the Intec Envelope Press. Their feeder makes sense and I've heard that another printer recently switched from the Xante Enpress to the Intec and has already run over 100k of envelopes thru it. The...

I regret buying my Xante Enpress. I can't get the enterprise feeder to consistently feed No. 10's. I have to place the palm of my hand on the guide rail to apply pressure on the envelope stream (that helps for awhile) but then jams. I've moved the feed roller up/down so many many many...

I regret buying my Xante Enpress. I can't get the enterprise feeder to feed No. 10's.

I agree. I regret buying my Xante Enpress. The envelope feeder is extremely difficult to use. I've gone thru sensors and a board - it still doesn't feed right. The Xante Tech said to revert back to an older version of IQue to set the belt speeds (which I did and still cannot adjust the...

I regret buying my Xante Enpress. I've had so many problems with using the feeder for #10 envelopes that I'm now printing them on my Konica Minolta. I've had to change out a number of sensors and now Xante is telling me to roll back to an earlier version of Ique so that I can adjust the belt...

Do you still like the EnPress?