Search results

Hi i want manual danmate 665 processor for dotmate7500 i will appreciated if help me regards

hi what is your problem about neopost machine?i repaired inserter and franking machine regards

dear All for material guide after clean you have to change parameter if i remember Guide LD or LB current you can decrease or increase for adjusting it and clear error regards

Dear friends i need diag software for signasetter .this software released in diskette(floppy disk)and all of machine have this software in floppy disk.it would be appreciated send files by internet to my e.mail. regards

dear all i need to buy hard drive (scsi 50pin) for signasetter.it will be appreciated if help me.regards

hi what is error on ld3?what is error in ld1 ?if have error on ld 1 can not work in ch1(0-7) as i remember check ld3 in laser power confirm not zero. this is good reference for each ld .it show situation of ld . regards

dear bortolinor you have to change floppy or floppy drive.eject floppy from herkules .give copy from floppy in new one.test herkules with new floppy.if problem not solved you have to change floppy drive. regards

Dear All any body have diagram of powersupply(24v)dotmate? we have problem in powersupply (fuse burn)when switch on dotmate thank you for your help . 9

hi you have to clean 3 sensor in arm .these sensors sense clamps place in load and unload. for better check in service mode sensor test as i remember ph27-1 ph27-2 ph27-3 regards

hi ali did you solve your problem? i think you are from iran. regards

Dear Ali i sent you private message did you receive it? regards

hi this is for material guide system can you send me files on floppy drive by mail? i send my e.mail address by private message. regards

hi please check vacuum unit (show 600 in expose time) and clean vacuum hole on drum 's surface . check angle of magenta and yellow in your rip.and another setting(dpi.dotahaoe.resolution) before this problem does plate setter work with this setting (70% and 600 rpm)? did you change your...

hi all we have very customer that used torrent rip(high water) with herkules(Linotype imagesetter work with speed way ). very fast and reliable and best choice. 9

Dear Brian i sent private message for you regards

Dear Stepal what is version on your ripmate? what is your dotmate "s model?(7500,7500p)is it online? i sent private message for you regards

Dear Mr Ankedo which side of plate you have problem?(zero of recording head or .....) you are from iraq .i am near of you from iran i sent private message for you regards

Dear all i have problem in tanto6120 imagesetter. after switch on machine and start intiolization ,,machine goes to ready mode but after ready mode does not work this means not accept data from rip and not load film not expose not any movement..... stay in ready menu. i dont know mybe eprom in...

dear revaza i sent you private message regards

Dear Hartmut thank you for your message problem has been solved regards