Search results

Picture A looks like it may be spinner motor encoder, cleaning the encoder should solve the problem. But has something else gone wrong to produce the results in pictures B and C

Most likely the cutter switch. If the miniature slide inside the switch is worn or dirty the electrical contact is not switching cleanly or fast enough

There’s a one way bearing in the center of the appeture disc it has possibly dried out does the disc rotate easily in both directions? there should some resistance in one direction only, the bearing may need a drop of lubrication

Go to utilities menu, switch to offline icon it won’t look for a processor, but it will look for a daylight cassette

If error 27 is flashing, try switching off the processor for one full minute then switch processor on. This will work if it is a temperature issue

05 wait = level low on gum bath. is fill pump constantly running But not drawing up chemical?

Where is this machine located?

Cheat door switch,shine flashlight into right hand side of Rack,run another prefeed or a real job, you should see activator raining down from spray bar? (3 jets) if not,this in the problem

Did you do another prefeed? Any trace of silver?

Hi What color is the plate? Black = fogged Silver=no exposure Purple=no activator from spray bar

Reseat flat ribbon cable on control panel,it might have been partially dislodged when refitting cover

your problem is with the spin motor, dirty encoder most likely causing lines, dirty optics are affecting exposure spin motor requires agfa service engineer. i am too far from scotland

As far as i can remember there is a magnet and a reed switch on the drive gear on the motor, perhaps the reed switch was knocked out of position and not sending back pulses to board, it counts the revolutions of the gear and controls speed,

i came across similar density issues on avantra 25 many years ago it was the Velcro strip dangling and moving in front of spin motor

looks like you now have a seperate fault,was the cpu powered down for more than two days?try to gently heat cpu board with hairdryer while powered up,it might boot up,

error 53,55 error 53,55 check to see if bridge rollers rotate freely in one direction only. if they rotate freely both ways problem with oneway bearing, is there any condensation in input section of processor? if yes check scavenger fan.

look for bridge rectifier on relay board it may be open circuit it provides 12v dc to cooling fan and scavenger fan and door circuit are these fans running? if not, it is the bridge rectifier.