Search results

Dear Members, I have come across the following error on trendsetter 800 Prompt 15076:"Autoloader:trailing edge clamps not on actuator" Check points and procedure to clear the error will be highly appericiated. Thanks

Dear Members, I am installing moz cptronic machine.when it is powered up the following errors happen and the machin is unable to run. INIT-TEST 1 SPK 000F flashing INIT-TEST 4 SEK FFFF flashing I have installed simi lar machine previously and SPK value must be 001F,what I can trace is only...

Hi everyone, i am asked to calibrate an avantra 30 imagesetter for the 2400 dpi resolution.first i imaged the exposure test from the image setter itself and i found exposure value of 200 is the correct exposure|(i measured using denisitometer and found 200 to be ok) but the dots are kind of...

Dear All, i was trying to adjust the exposure setting of screen FT-R30550 imagesetter.in the laser exposure setting i used to output jobs at 3000dpi resolution and expousre intensity of 300.previously it was possible to increase the intensity beyond this point ,but now i don't know what goes...

I will as soon as i reach where the equipment is located.Thanks

dear Farshad i was unable t test your instructions because the avantra is located in remote area i will travel there and give you feedback rightaway.thanks for your support.

thank you all for showing keen interest in helping me.Vlad thank you very much.i just unchecked fill the whole drum option and know i am here to thank you.i have touched some of the delicate parts of the machine and i was not sure what to do next.

hi everybody i'm trying to adjust a 0.1mm registration problem while imaging a full colored A4 job on xitron navigator 7rip using the media saving option. The two separated colors (cyan, magenta) and( yellow,black) are correctly registered. but in the direction where media is moving the second...