Search results

I bought this cutter used. It does a decent job for what I need it to do, BUT: 1) the back guage is 5MM off from the display 2) The display is set to MM and I would prefer inches. I have contacted the manufacturer, but they were no help. I'm hoping someone with one of these cutters can help...

Recently my D125 has started doing something strange. The Finisher is cycling (rises and lowers often during a job). The Fix suggested is get a firmware fix (SHA-256). I don't have a service contract with Xerox. Is there a way for me to get this firmware fix?

Is there a way to turn off Paper Tray Confirmation of stock? When I run NCR numbered forms, I run one ream at a time. Half the time I forget to hit the confirm button. It would be great if I could turn it off.

Thanks, good advice

Many thanks, pippip

Ok, I'm embarrassed to ask this question (I should know it, but don't). I use InDesign, create a form, 8 1/2" X 11" image, centered, (no bleed). I am printing on a Xerox D125 B&W copier. The printed image is not centered on the sheet. I use the Image Shift to center the image. How do I create a...

Windows system. Alt+Control+Shift tried. Same result. With no document open -> Type -> Font -> no drop down list at all!

I don't use Illustrator much, but I just noticed I only have access to Myriad Pro font. Generally I use InDesign, which has a lot of fonts. After reinstall, no change. Any thoughts?

Model 19 PLC Serial 44806A1214

I just downsized. My new place doesn't have room for my old 30.5" Challenge. I bought a used EMB 19 PLC cutter. Does anyone have one? What about a manual? Any experienced help appreciated, Ralph Manassas, VA

Thanks for the pictures. I will examine to see if anything is stuck in there.

Thank you for the suggestions.

Ah Ha! The game is afoot! Second side paper path is our main suspect.

Good idea! I will try it.

Ok, for all you V180 owners. I am printing a job, single sided, 20# cotton writing stock. Pulling from paper tray 1, stacking on top output tray. If I finish FACE DOWN, I get a dog ear on the leading edge. If I finish FACE UP, no dog ear, runs perfect! Any idea's? (Yes, I ran the job face...

Thanks, I will try that too.

Thanks, I will give it a try

I have two systems. System A, when I add printer, finds V180 does the install, shows Driver Xerox EX-i 180 Print Server US 1.2. System B (when I do the exact same) shows Driver Microsoft PS Class Driver. I can click on the down arrow and see a list of print drivers. This list shows Xerox EX-i...

Mystery Solved! Turns out, the bearing on the Shift Screw had moved out of place. Letting the Shift Screw Gear move out of position, therefore no homing. Put the bearing back in place. Problem Solved!

I have taken the side panel off. I can see the lower tray homing, but the top tray doesn't home. There are three sensors on the inside back left corner, that correspond with three metal tabs on the tray. Has anyone had this problem? If so, how do you find the bad sensor or do you replace all...