• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

Aqueous Coating Cracks

aqazi81

Well-known member
Hi All,
We are facing issue with coating cracks on heavier coverage areas. Low coverage areas have no issue or very little visible.
Please view the attached images of the issue.
IMG_20170527_135553.jpg
 

Attachments

  • IMG_20170527_135553.jpg
    IMG_20170527_135553.jpg
    3.5 MB · Views: 343
Here's a couple of troubleshooting guides the answer may be in there somewhere

https://www.fujifilmusa.com/shared/bin/TroubleshootAC.pdf

https://www.fujifilmusa.com/shared/bin/AqueousCoatingGuide.pdf

https://printplanet.com/forum/press-technology/sheetfed-web-offset-discussion/9530-aqueous-coatings


The best answer seems to come right from this forum mud cracking", the coating is drying too fast on top of a heavy build.

Make sure the coating is at least 20 seconds (Zahn#3)
Turn the IR's down, along with the hot air knives
Speed up the press
Increase amount of coating (if you have an adjustible coating system)


Good luck
 
Hello aqazi81


The problem you see is - Reticulation, trying to overprint Printing Ink with a Water based fluid is not a good idea.

Yes - I know Aqueous OP are widely used, Think- Surface Tension Problem


Regards, Alois
 
Mud Cracking.

The coating is drying faster than the ink underneath. As the coating is applied to the film of ink(s) underneath, it's crawling giving the 'Alligator Skin' look. Talk to your coating suppliers about a slightly slower drying coating.
 
Have you done a AQ coating weight test?
What BCM roller are you running?
Do all your different coating types have the same issue?
 
CKL - Good points. If he's running a roller coater, than BCM is irrelevant. He can certainly check his coating stripe and measure viscosity using a Zahn #3.

Aqazi - Is this happening with Gloss, Satin, or Matte? Or all coatings?
 

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top