• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

AV44 20k spinner need repair error 149

ChrisZ

Well-known member
Hello.
In Avantra 44 I have error message 149 Spinner did not lock. Encoder and sensor is clean. It turns smoothly so I suspect problem with it's electronics.
Is there any company preferably in EU able to repair spinner electronics?
Thanks, Chris
 
Did you make any changes to the Spinner setting in the unidiag? Have you found any problem with the spinner?If the answer is no, then there is definitely a problem with the DEC board..

contact me if you need help.

Farshad Faghihi
Armya Inc.

[email protected]
 
Last edited:
No changes were made. Machine was just giving 149 time to time but was working after "warmup". Now 149 is all the time.
Can I diagnose it somehow to make sure it is DEC board? I have cable, software and a few years of experience.
Already replaced carriage controller board for a test, no difference.
Chris
 
Last edited:
Chris,

There problem is the DEC board if you haven't made any changes to Spinner setting.
There is no need to replace the DEC board completely. It can be repaired . The investment for repair is $350 USD. It is a 2 hours work .

If you are ready to invest that amount send me an Email to

[email protected].

Regards

Farshad
 

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top