Celebrant 6.1 | Media Profiler

[R&D]

While printing from Celebrant 6.1 Fuji RIP to our Epson sherpa proofer 9880, the lowest clickable resolution is 300 dpi (which is too high for a low resolution proof). How can we create a lower resolution in the Media Profile Characteristics of Media Profiler 6.1 ?

many thanks

 

[RAMESH]

Dear All,

How to configure the celebrant rip to input the One bit tiff file. While inputting one bit tiff file, it is taking more than 12 minutes to process single separation. The reason I found it doing "active painting".
I hope this process is normally for the PDF input.

I have seen the same rip at other printing press, which is taking only 2 minutes to process. So I compared that rip and matched the same settings to my rip and the system spec are also same.

Still I have not find any improvment in the speed?

Kindly help me?

regards
ramesh subramani